Shop

Cuts soft metal wire “flat” without crushing it, increasing work efficiency!

These double-edged nippers are designed specifically for cutting soft metal wire, focusing on metal wire diameters commonly used in model making.

With ordinary nippers for metal wire, the cut surface tends to be crushed, but these nippers can finish the wire almost “flat”.

Since the cross section of the metal wire does not swell after cutting, it can be inserted directly into a hole made with a drill of the same diameter, making shaft driving easier.

Specifications

• Double-edged nippers for metal wires
• With spring
• Total length: Approx. 125mm
• Weight: Approx. 65g
• With cap

Cutting capacity

• Brass wire: 0.5mm-1.5mm (base)
• Copper wire: 0.5mm-2mm (base)
• Aluminum wire: 0.5mm-2mm (base)
• *Etched parts cannot be cut

Precautions

• Do not cut wires other than the intended materials
• For safety, wear protective glasses
• There is a risk of the target flying, so make sure there are no people around and no fragile objects before working
• Do not touch the cutting edge directly
• Do not apply a load greater than the capacity. Be especially careful of the load on the tip
• To prevent rust, wipe off dirt and fingerprints and apply oil to the shaft and cutting edge
• Store in a case out of reach of small children