Shop

Specially designed hexagonal shaft drill bit for model making!
You can drill holes without worrying about freewheeling.

A set of 8 drill bits with a 4mm hexagonal shaft and drill diameters of 2.1mm, 2.2mm, 2.3mm, 2.4mm, 2.6mm, 2.7mm, 2.8mm, and 2.9mm.

– The hexagonal shaft fits securely with the connecting part, so you can work with confidence without worrying about it spinning freely.

– Compared to general drill bits, the overall length is shorter and the distance to the target is closer, making it easier to aim and control the focus.

– The tip of the drill bit is designed with a blunt angle, so it can dig shallowly and can dig holes without penetrating thin plastic boards.

– Since it digs more slowly than a sharp-angled tip, it is less likely to shake and the hole is less likely to distort. The edges of the dug hole are also finished neatly.

– In addition, a cutting edge has been added to the tip of drill bits over 1.5mm!

– The increased biting force allows you to dig with light force without resistance.

What’s more! If you use the magnetic “Quick Power Pin Vise” (sold separately), it can be easily attached by simply inserting it! !
Attaching and detaching the pin vise is very easy, increasing work efficiency!

Maintenance is also important! Maintain it properly to use it for a long time!
Remove any cutting chips after use.
After use, wipe off any fingerprints and apply anti-rust oil.
Sebum can cause rust, so be sure to wipe it off with a clean cloth.
After use, be sure to store it in the case.
Do not store in a humid place.