Shop

Specially designed hexagonal shaft drill bit for model making!
You can drill holes without worrying about freewheeling.

Set of 5 with 4mm hexagonal shaft and 0.5mm, 0.6mm, 0.7mm, 0.8mm, 0.9mm drill diameters.

-The hexagonal shaft fits securely with the connecting part, so you can work with confidence without worrying about freewheeling.

-Compared to general drill bits, the overall length is shorter and the distance to the target is closer, making it easier to aim and control.

-The tip of the drill bit is designed with an obtuse angle, so it can dig shallowly and dig holes without penetrating thin plastic boards.

-The drill bit digs more slowly than a sharp-angled tip, so it is less likely to shake and the hole is less likely to distort. The edges of the holes you dig will also be finished neatly.

What’s more!
If you use the separately sold magnetic “Quick Power Pin Vise”, you can easily attach it by simply inserting it! ! It is very easy to attach and detach from the pin vise, increasing work efficiency!

Maintenance is also important! Maintain it properly to use it for a long time!

– Remove any cutting chips after use.

– After use, wipe off any fingerprints and apply anti-rust oil.

– Oils from your skin can cause rust, so be sure to wipe them off with a clean cloth.

– After use, be sure to store it in the case.

– Do not store in a humid place.